S. P. Wang, X. Y. Huang, H. X. Chen, N. A. Liu and G. Rein (2015) Ignition of low-density expandable polystyrene foam by a hot particle. Journal/Combustion And Flame 162 4112-4118. [In English]
Web link: http://dx.doi.org/10.1016/j.combustflame.2015.08.017
Keywords: Building fire dynamics, EPS, Insulation materials, Embedding ignition, Rolling ignition, Mixing time, FUEL BEDS, FIREBRANDS, CELLULOSE
Abstract: Insulating materials are ubiquitous in modern buildings for improving energy efficiency, but their high flammability becomes a significant fire safety issue. Many large fires in high-rise buildings were caused by the ignition of insulating materials by hot particles from fireworks and welding processes. Such ignition event is fundamentally different from the traditional flame or radiation driven ignition assumed in the literature, and still presents significant knowledge gaps. In this work, we study experimentally the ignition of a widely used insulation materials, expandable polystyrene (EPS) foam, by a hot steel particle under different conditions. In the experiments, a small spherical particle (6 similar to 14 mm in diameter) was heated to a high temperature (>,900 degrees C), and then placed on a bench-scale low-density (18 or 27 kg/m(3)) foam sample. It was observed that flaming ignition could only occur on the foam surface during its rolling process (rolling ignition) or before it was fully embedded (embedding ignition). The measurements suggested that larger particles held lower critical temperatures for ignition, which decreased from 1030 to 935 degrees C for diameters increasing from 6 to 14 mm. Compared to higher-density forest fuels in the literature, the critical particle temperature of EPS foam is much higher, with a narrower transition region for ignition probability of 5-95% and has a weaker dependence on the particle size. Results also show that both the sample density and thickness have a negligible influence on the ignition probability and mass-loss ratio. Theoretical analysis suggested that the hot particle acts as both heating and pilot sources, and the ignition of EPS foam is controlled by the competition between the gas mixing time and the particle residence time. (C) 2015 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
 ,